Category Archives: cnc@cncGlass.com EVA film glass interlayer

SGP INTERLAYER Made in China, Not Dupont, Not Kuraray, but China Brand SGP ionoplast Interlayer for Structural Laminated Safety Glass SGP: 100 times stiffer and 5 times stronger than PVB used as anti-explosion or anti-hurracane solution Made In China Replacing“Dupont”Kuraray SGP  Color: Super clear Thickness:0.76mm Width:1650mm, 2000mm or 2440mm Liner length per roll:50M, 100M, 150M …

Continue reading “”

CNC02-Continuously-Working Thermal Cutter is available for high point temperature adjustment, 16 sections of temp to set. Peter Lin, cnc@cncGlass.com, cnc@cncEVA.com Whatsapp: 0086 15013829504, WeChat: WeCan365 www.cncGlass.com www.cncEVA.com Differences between CNC02 and CNC01: *CNC02-Continuously-Working Thermal Cutter is designed for continuously working with air cooling system, while CNC01-Intermittently-Working is only for short time working, you need to release the button intermittently for cooling after short time heating in case itself gets too hot. *CNC02-Continuously-Working is able to trim the edges with minimum of smoke and no burned marks. *CNC02-Continuously-Working is lighter ,only 610g, easier to handle, while CNC01 is 950g. *CNC02-Continuously-Working is available for high point temperature adjustment, 16 sections of temp to set. So you don’t need to let the blades going up to 500C degrees each time you use it, you may only set the lower temperature(for example about 300C degrees) only if it’s high enough for you to trim interlayer remains, so you can prolong the life time of the blades, and save cost.

CNC02-Continuously-Working Thermal Cutter is available for high point temperature adjustment, 16 sections of temp to set. Peter Lin, cnc@cncGlass.com, cnc@cncEVA.com Whatsapp: 0086 15013829504, WeChat: WeCan365 www.cncGlass.com www.cncEVA.com Differences between CNC02 and CNC01: *CNC02-Continuously-Working Thermal Cutter is designed for continuously working with air cooling system, while CNC01-Intermittently-Working is only for short time working, you need to release the button intermittently for cooling after short time heating in case itself gets too hot. *CNC02-Continuously-Working is able to trim the edges with minimum of smoke and no burned marks. *CNC02-Continuously-Working is lighter ,only 610g, easier to handle, while CNC01 is 950g. *CNC02-Continuously-Working is available for high point temperature adjustment, 16 sections of temp to set. So you don’t need to let the blades going up to 500C degrees each time you use it, you may only set the lower temperature(for example about 300C degrees) only if it’s high enough for you to trim interlayer remains, so you can prolong the life time of the blades, and save cost.